#35 XD XDM Striker Retainer Pin

#35 XD XDM Striker Retainer Pin
Click To Enlarge
  • Item #: XD0914
  • Manufacturer: Springfield Armory
  • Manufacturer's Product Number: XD0914
  * Marked fields are required.
Qty*
Price $2.50
Availability In-Stock

Striker Retainer Pin

The factory striker retainer pin can be located on the top of the slide as seen in the picture above by the red arrow. The factory part is a 3mm x 16mm carbon steel split roll pin. The same pin is found in all XD and XDM pistol slides and is considered a consumable part that should be replaced every couple thousand rounds or with prolonged dry-firing. Springfield Armory receomends use of snap caps to extend the life of the part during dry-firing sessions. If you notice that this roll pin keeps working it's way out of the slide it should probably be replaced. 

Installation

These are brand new virgin pins that have never been installed into a pistol before. These will be hard to install into the slide, it is recomended that you slightly squeeze one end and start with that tapered end. This will make it easier to start the pin into place. We can install these pins for 5.00. 

http://shop.xdman.com/Striker-Retainer-Pin-Installation-Retainer-Pin-Install.htm